Home use oil seed expeler, seed oil pressing machines
Widely applied oilseeds:
Leader'e main business scope:
10-500T/H oil material first cleaning, drying and storage section turn-key project;
100-3000 T/D oil pretreatment, shelling and pre-press workshop turnkey project (soybean hot
peeling, bean skin crushing; the soybean extrusion, high oil contained pre-press cake extrusion,
and high oil contained embryos puffed; of direct puffed). Rice bran production line turn-key project;
100~300TPD Leaching workshop turnkey project (Towline extractor, Rotocel extractor, loop
type extractor, DTDC separated machine, the full negative pressure evaporation, paraffin wax
recovery, leaching workshop degum, phospholipid concentrate);
30-1000T/D oil continuous grade one or two physical (chemical) refining production line;
20-3000T/D sunflower oil, rice bran oil, corn germ oil dewaxing turn-key project;
10-200T/D Fatty acid esterification production cooking oil production line.
Display of Leader'e machines:
How to operate this machine?
1. When the machines run freely normally, feed small amount of oilseeds uniformly slowly, so as to grind the machine chamber, checking whether itâs normal or not when the cakes come out. If it canât be discharged smoothly, it may be the reason of too small gap, adjust hand wheel clockwise. If the cakes are discharged too much too fast, adjust hand wheel counterclockwise till it can work normally. Then increase the input capacity gradually, so as to avoid non-uniform feeding, loading rise suddenly, resulting in blockage.
2. The working temperature of press machine depends on the oilseeds variety and humidity. The higher machine temperature is needed if the input material is too dry, on the contrary, the temperature can be lower. Normally, the oil can be extracted out when the machine temperature is about 60â. The normal production can be started when you can feel itâs hot while you touch the machine body.
3. Adjust the meal thickness to 0.3mm~1.0mm, adjust nut and increase feeding capacity when it reaches requirement.
4. Check the cake discharging frequently during the production. Stop feeding when the cake canât be discharged smoothly or non-discharging.
5. Clean the slag leakage constantly so as to avoid blocking of oil-way. The recycled slag can be feed back to hopper and press again.
6. During the second pressing, the meal should be broken into 10mm or so pieces, and this can avoid disordered feeding. Normally, soybean is pressed 2 times, peanut and cottonseed can be pressed 2~3 times.
7. The machine should be stopped immediately and clean it, once the metal or other tough substances are found in the chamber.
8. Close the bottom spile in the feed inlet and stop feeding 1~2 minutes before stop the machine. Make screw go backward by 2~3 cycles, so the residues can be discharged.
What certificates do Leader'e have?
Still have questions?
What should you do??
Do not worry!
SAM is always here!!
Just knock me!!!